Autowinder Winch System
A roll up wall system will supply substantial control over the internal environment and may be adapted to most building designs.
A steel round guide tube (25.4mm O/D outer diameter) is located vertically through the roller guide of the winch itself and may be purchased as a separate part if you do not have this.
The roll up wall tube that runs the length of the wall horizontally and is turned by the Autowinder winch is a 25mm NB Pipe (33.3OD) pipe section – order as many as required for your length wall. The pipe is “swagged” at one end so that it may sleeve together, small ‘wafer head” screws will be needed to lock the joints together.
The other part of the roll up wall system is the “Polyclamp” grips – that secure the roll up wall material to the rolling pipe. (Allow a minimum of one Polyclamp per metre)
Redpath recommend Polyweave reinforced greenhouse film for the roll up wall sheeting (see below) + windbreak wall screening (see below) for the outer barrier netting may be used to hold the roll up wall against the greenhouse poles. If windbreak is not used, then some Polybelt webbed strapping will be needed to keep the roll up wall tight against the poles of the building.
Kit Includes - Autowinder Motor (4.0rpm, 3.7amp, 60Nm of Torque), Brass Adapter, Roller Guide & M8x50mm Stainless Bolt & Nut
Roll Up Curtain Accessories
25NB Galvanized Steel Pipe (33.3OD) 2.0mm wall thickness x 3250mm long with 75mm Swagged one end
* Discount on 10+ Lengths*
25NB Galvanized Steel Pipe (33.3OD) 2.6mm wall thickness x 3250mm long with 75mm Swagged one end
* Discount on 10+ Lengths*
38mm x 25m Per Roll. Used to secure roll up walls when no external screening is used, or in extremely windy conditions.
Can be used in a X pattern in windy locations.
38mm x 25m Per Roll.