Ridder Tube Motor Accessories
Adjusting switch for the RB50Eᵖˡᵘˢ and RB120Eᵖˡᵘˢ tube motors for 1-phase, 230 V/50 Hz should be used when setting up the RB50/120Eᵖˡᵘˢ tube motor. The end position of the tube motor can be set up, changed or re-set using the adjusting switch. The adjusting switch has a plastic connector with pressure clamps (for connecting the RB50/120Eᵖˡᵘˢ tube motor), a switch unit with push buttons and a rim-earth plug.
Mounting kit for attaching the cable carrier to the guiding unit or the cable carrier bracket for the RB50Eᵖˡᵘˢ and RB120Eᵖˡᵘˢ tube motors for use in greenhouse structures. Mounting kit consists of two end clips for the cable carrier, 4 pop-rivets and 3 cable ties.
Zinc-plated guiding unit used to conduct the RB40/50-RB50Eᵖˡᵘˢ tube motors in the guide rail. Capable of absorbing the torque and axial forces of the tube motor. The tube motor is fitted to the guiding unit with a square shaft pin (10×10 mm) and secured with a split pin.
The cable carrier guides and protects the power cable of the tube motor. The cable carrier is hinged in one direction and rigid in other directions . The power cable can be fed in easily. Attach the cable carrier to the tube motor using the mounting kit.
Zinc-plated mounting bracket used with the cable carrier end connection (female) for tube motors
Zinc-plated bracket for mounting the cable carrier to the RB50Eᵖˡᵘˢ tube motor. The bracket should be mounted on the tube-motor head between the tube motor and the guiding unit.
The RMC50 motor control units are control boxes used to connect the 1-phase RB50/ RB50Eᵖˡᵘˢ tube motors. In the RMC50 motor contol unit, all the electric components needed to ensure the safe operation and the safe connection and drive for a RB tube motor.
For use with guiding units for the RB50Eᵖˡᵘˢ/120Eᵖˡᵘˢ, RB40/50 and RB120 tube motors. Guide rails can be supplied with a zinc-plated mounting bracket. Supplied in 4000mm lengths.